[nsp] Maximum 2 MBPs Serial Ports in the 2610

[Fast Track Technologies]

Thanks Mark,

As I understand the 2610 does not support the NM-1FE2W / NM-2FE2W..

Regards
Sunil

----- Original Message -----
From: "Mark Tinka" <mtinka at africaonline.co.sz>
To: "'Fast Track Technologies'" <fast_track at vsnl.com>;
<cisco-nsp at puck.nether.net>
Sent: Thursday, March 25, 2004 1:49 AM
Subject: RE: [nsp] Maximum 2 MBPs Serial Ports in the 2610


cisco-nsp-bounces at puck.nether.net wrote:
> Hi,

Hello.

>
> Can I get (6) 2MBPs Serial Ports in the CISCO 2610 (not the 2610XM) -

That would have been very easy if the 2600 supported the NM-4T network
module. You'd have the 2x WIC-1T in the integrated slot, and add the NM-4T
in the other slot. Unfortunately, the 2600 doesn't support the NM-4T. It
will only run on 3620, 3640, 3660, 2691, 3725 and 3745.

> say, (2) WIC-2Ts and (1) NM-2W with either (2) WIC-1Ts or (1) WIC-2T?

What you could is have 4 smart serial interfaces in your integrated slot,
two for each WIC port. You can then install an NM-2FE2W into slot1, and have
2x NM-WIC-1T in there.

>
> Thanks
> Sunil

However, why are you looking at the 2610? It only has one Ethernet port,
running at only 10Mbps? Unless the router is going to be an access
aggregator feeding into a larger router?

>
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp archive at
> http://puck.nether.net/pipermail/cisco-nsp/

Regards,

Mark Tinka
Technical Manager, Africa Online Swaziland