[nsp] dot1q subints on 6500/sup720

[Tomas Daniska]

simon,

> > or vlan translation could help you
> > 
> > 
> http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/122sx/swcg
> > /v
> > lans.htm#wp1044990
> 
> That looks like it'd do the job, but... 
> 
> prt0.thdo(config-if)#switchport vlan mapping 101 4090 %VLAN 
> mapping is supported on layer 2 switch port only.
> 
> ...so I can't use it in combination with dot1q subints. 
> Hmmm... Could have been good otherwise ;-(

i supposed you were talking about using l2 swtitch ports with
overlapping vlan id's

of course you have to configure it on the switch port. you configure
VLAN translation on each
port to yours-assigned vlans, and then use vlan interfaces for runing IP
stack


--

deejay