[nsp] Interface ethernet resets

[elatour at cimex.com.cu]

Hardcording both sides, all is ok!!!

Thanks,Jon


-----Original Message-----
From: Jonathan Maiman [mailto:Jonathan_Maiman at cnt.com] 
Sent: Tuesday, May 11, 2004 6:43 AM
To: DT-Eugenio Latour
Cc: cisco-nsp at puck.nether.net
Subject: RE: [nsp] Interface ethernet resets


 Latour,

	Late collisions typically indicate a duplex mis-match.  Check
the FastE interface settings in the 1720 and the device it is connected
to.  In general, I recommend hardcoding FastE interfaces connections for
Cisco routers to full-duplex and 100Mbps both on the router side and the
switch (or other device) side of the connection.   Autonegotiation
rarely works correctly for Cisco FastE router interfaces.


							--Jon


-----Original Message-----
From: cisco-nsp-bounces at puck.nether.net
[mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of
elatour at cimex.com.cu
Sent: Tuesday, May 11, 2004 8:35 AM
To: cisco-nsp at puck.nether.net
Subject: [nsp] Interface ethernet resets
Importance: High

I have a router Cisco 1720,in which the fastethernet interface have,
i.e.,230 interface resets and 230 ethernet late collisions. What is the
meaning of that?

Thanks in advance,
Latour.

PS:
The conf of this interface:

interface FastEthernet0
 ip address 172.17.3.222 255.255.255.224  ip access-group 102 in  no ip
route-cache  no ip mroute-cache  speed auto


_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/