[c-nsp] Unknown reason for High CPU 3620
Alex Foster
afoster at gammatelecom.com
Wed Nov 3 08:37:07 EST 2004
I have a 3620 that is currently maxing out its CPU for no apparent
reason - the traffic load on it at the moment is about 1 to 2 meg - and
sh proc cpu doesn't indicate any process that is causing the high CPU
util. Most of the traffic is SIP but I wouldn't have thought this would
have any bearing. There are only two interfaces on the box in use - an
ATM 155 and a 10bt. The traffic from the 10bt is bridged to a PVC on
the ATM interface - nothing complicated.
#sh proc cpu
CPU utilization for five seconds: 96%/93%; one minute: 90%; five
minutes: 91%
PID Runtime(ms) Invoked uSecs 5Sec 1Min 5Min TTY Process
1 194708 9899756 19 0.00% 0.00% 0.00% 0
Load Meter
2 2008 223 9004 1.41% 0.13% 0.03%
66 Virtual Exec
#sh mem sum
Head Total(b) Used(b) Free(b) Lowest(b)
Largest(b)
Processor 61D70EA0 12120416 6616992 5503424 5303744
5305428
I/O 2900000 7340032 4387068 2952964 2920520
2947260
#sh int e1/0
Ethernet1/0 is up, line protocol is up
Hardware is AmdP2, address is 0005.3245.e070 (bia 0005.3245.e070)
Description:
MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec,
reliability 255/255, txload 34/255, rxload 37/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output 00:00:00, output hang never
Last clearing of "show interface" counters 1y4w
Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 103522 drops
5 minute input rate 1470000 bits/sec, 1984 packets/sec
5 minute output rate 1355000 bits/sec, 2166 packets/sec
2150894411 packets input, 1646909945 bytes, 0 no buffer
Received 88151770 broadcasts, 0 runts, 0 giants, 0 throttles
6397644 input errors, 42166 CRC, 32878 frame, 0 overrun, 6355422
ignored
0 input packets with dribble condition detected
2681876495 packets output, 1769855380 bytes, 0
underruns(556991/1663306/0)
165 output errors, 2220297 collisions, 50 interface resets
0 babbles, 47 late collision, 1067254 deferred
118 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
#sh int atm 0/0.2
ATM0/0.2 is up, line protocol is up
Hardware is RS8234 ATMOC3
MTU 4470 bytes, BW 155000 Kbit, DLY 80 usec,
reliability 255/255, txload 2/255, rxload 2/255
Encapsulation ATM
3075506957 packets input, 1094442885139 bytes
2362546968 packets output,988686523562 bytes
0 OAM cells input, 0 OAM cells output
AAL5 CRC errors : 81
AAL5 SAR Timeouts : 0
AAL5 Oversized SDUs : 0
AAL5 length violation : 26
AAL5 CPI Error : 0
Thanks
Alex
The information in this e-mail and any attachments is confidential and may be subject to legal professional privilege. It is intended solely for the attention and use of the named addressee(s). If you are not the intended recipient, or person responsible for delivering this information to the intended recipient, please notify the sender immediately. Unless you are the intended recipient or his/her representative you are prohibited from, and therefore must not, read, copy, distribute, use or retain this message or any part of it. The views expressed in this e-mail may not represent those of Gamma Telecom.
This message has been scanned for viruses by MailController
More information about the cisco-nsp
mailing list