[c-nsp] EIGRP Adversing Problem

[Mark]

Oliver,

can you write down an example of distribute-lists out for a specific 
network?

Mark


On Oct 26, 2004, at 7:59 PM, Oliver Boehmer ((oboehmer)) wrote:

> Jason Lixfeld <> wrote on Tuesday, October 26, 2004 7:38 PM:
>
>> Use the eigrp router passive-interface command.
>>
>> http://www.cisco.com/en/US/tech/tk365/tk207/
>> technologies_tech_note09186a0080093f0a.shtml
>
> passive-interface will only prevent an EIGRP adjacency being formed 
> over
> this link, the link address will still be advertised.. the only way to
> prevent this from happening was mentioned by Bruce earlier :
>
>> Well, it depends.  You could adjust your "network" statements in EIGRP
> to
>> not include that network or subnetwork.  Or you could use
> distribute-lists
>> to filter it out.
>
> In halfway modern code (at least 12.2 and later, I think 12.1 as well)
> you can use "network <network> <wildcard>" to exactly specify the
> interfaces' addresses which you want to be covered by EIGRP.. works
> similar to the way you setup OSPF..
>
> 	oli
>