[c-nsp] strange and sudden ATM drops - any ideas?
Christopher J. Wolff
chris at bblabs.com
Mon Sep 6 03:02:25 EDT 2004
Hello,
I have a peculiar situation with two ATM interfaces that occasionally drop
(and restart on their own, or when shut/no shut). The router interfaces
have been replaced with new cards, as well as all connecting cables. Thank
you in advance! Here are the configurations:
Router 1:
interface ATM4/0
description OC3-TA
ip address XXX.XXX.XXX.90 255.255.255.252
no ip redirects
no ip unreachables
no ip proxy-arp
ip accounting access-violations
ip nat outside
ip route-cache flow
ip ospf network point-to-point
ip ospf cost 1000
load-interval 30
no atm ilmi-keepalive
crypto map Int-ATM4/0
pvc rsvp-ctl 0/51
protocol ip XXX.XXX.XXX.89 broadcast
no broadcast
!
ATM4/0 is up, line protocol is up
Hardware is RS8234 ATMOC3
MTU 4470 bytes, sub MTU 4470, BW 155000 Kbit, DLY 80 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ATM, loopback not set
Encapsulation(s): AAL5
1023 maximum active VCs, 1 current VCCs
VC Auto Creation Disabled.
VC idle disconnect time: 300 seconds
Last input 00:00:00, output 00:00:00, output hang never
Last clearing of "show interface" counters 00:06:12
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 9?
Queueing strategy: Per VC Queueing
30 second input rate 5000 bits/sec, 7 packets/sec
30 second output rate 8000 bits/sec, 9 packets/sec
2616 packets input, 337492 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
3234 packets output, 440184 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
Router 2:
interface ATM5/0
ip address XXX.XXX.XXX.89 255.255.255.252
no ip redirects
no ip unreachables
no ip proxy-arp
ip accounting access-violations
ip route-cache flow
ip ospf network point-to-point
load-interval 30
atm clock INTERNAL
no atm ilmi-keepalive
pvc rsvp-ctl 0/51
protocol ip XXX.XXX.XXX.90 broadcast
no broadcast
oam-pvc 0
!
ATM5/0 is up, line protocol is up
Hardware is ENHANCED ATM PA
MTU 4470 bytes, sub MTU 4470, BW 149760 Kbit, DLY 80 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ATM, loopback not set
Encapsulation(s): AAL5
4095 maximum active VCs, 1 current VCCs
VC idle disconnect time: 300 seconds
151 carrier transitions?
Last input 00:00:04, output 00:00:00, output hang never
Last clearing of "show interface" counters 00:26:10
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 9?
Queueing strategy: Per VC Queueing
30 second input rate 8000 bits/sec, 7 packets/sec
30 second output rate 6000 bits/sec, 5 packets/sec
6444 packets input, 901127 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
2 input errors, 2 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
5341 packets output, 637732 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
More information about the cisco-nsp
mailing list