[c-nsp] Sup720 won't log link status changes? WTF?!

[Robert A. Hayden]

Per the notes, the command is apparently not supported on the sup720.  My
tests indicated also that the command had no effect.

On Tue, 14 Sep 2004, Jay Ford wrote:

> On Tue, 14 Sep 2004, Jared Mauch wrote:
> > On Tue, Sep 14, 2004 at 09:26:08PM +0200, sthaug at nethelp.no wrote:
> > > > Along the way I discover that the logs on the routers no longer show when
> > > > a port physically go up or down.  It will trap, but nothing actually
> > > > occurs in the log files.  Of course, the "logging event link-status"
> > > > command is still accepted, it just doesn't work.
> > > >
> > > > So, opening a case with TAC about this rather obvious shortcoming results
> > > > in the typic "it's supposed to be that way" response along with an
> > > > invitation to submit a feature request.
> > > >
> > > > (Relevant release note buried so deep nobody could find it):
> > > > 	http://tinyurl.com/4a7kb
> 
> It seems that the interface command "logging event link-status" is required
> to enable link up/down logging.  That should be enabled by default in my
> opinion, but at least it seems to be there.
> 
> ________________________________________________________________________
> Jay Ford, Network Engineering Group, Information Technology Services
> University of Iowa, Iowa City, IA 52242
> email: jay-ford at uiowa.edu, phone: 319-335-5555, fax: 319-335-2951
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>