[c-nsp] ieee bridge over gre question.

[David Prall]

I just tried this. The "bridge?" doesn't return anything. But, "bridge-group
1" was accepted and stayed in the config. It did give an error message:
% This command is an unreleased and unsupported feature

Of course I can't get any traffic to pass over the Tunnel Interface.

This was under a 12.3T Interim Build

David

--
David C Prall dcp at dcptech.com http://dcp.dcptech.com
  

> -----Original Message-----
> From: cisco-nsp-bounces at puck.nether.net 
> [mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of 
> lists at hojmark.org
> Sent: Monday, April 04, 2005 5:35 PM
> To: 'Andriy A. Yerofyeyev'
> Cc: cisco-nsp at puck.nether.net
> Subject: RE: [c-nsp] ieee bridge over gre question.
> 
> > Can I configure and use bridge over gre like this :
> 
> In my experience (years ago, however), bridging over GRE 
> works OK, but it's
> not supported and the router will even tell you so, when you 
> configure it.
> 
> Have you looked at L2TPv3?
> 
> -A
> 
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>