[c-nsp] hardware- 3745 NM-1T3/E3 line card Troubleshooting

[Tim Bulger]

Have a look at the "controler t3|e3" command...

-Tim 

-----Original Message-----
From: cisco-nsp-bounces at puck.nether.net
[mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of Scott Ingram
Sent: Tuesday, April 19, 2005 3:55 PM
To: cisco-nsp at puck.nether.net
Subject: [c-nsp] hardware- 3745 NM-1T3/E3 line card Troubleshooting

Software Version: c3745-ipbase-mz.123-2.T.bin
 
Problem Details: I have a 3745 that I have just added a T3 card and
reloaded the router.  I see in "sh diag" and "sh version" the card   
is listed however, when I do a "show run" or "sh INT" the port is not
listed.    Any ideas??
 
 

 


IMPORTANT NOTICE:

This message is intended only for the use of the individual or entity to
which it is addressed and may contain information that is privileged,
confidential and exempt from disclosure under applicable law.  If you have
received this message in error, you are hereby notified that we do not
consent to any reading, dissemination, distribution or copying of this
message.  If you have received this communication in error, please notify
the sender immediately and destroy the transmitted information.

_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/