[c-nsp] vlan trunking on 10M ethernet

Justin M. Streiner streiner at cluebyfour.org
Fri Aug 19 13:17:12 EDT 2005


On Fri, 19 Aug 2005, CLAEREBOUDT Elke wrote:

> Is it already possible to do vlan trunking on a 2600 router with a 10M
> ethernet interfaces, or is it only supported on fast ethernet

It is possible, and I have this running on a few routers.  Note that it 
requires I believe a minimum of 48 MB of RAM and 16 MB of flash.

xxxxx.gw uptime is 4 weeks, 6 days, 1 hour, 17 minutes
System returned to ROM by power-on
System restarted at 13:12:01 edt Sat Jul 16 2005
System image file is "flash:c2600-j1s3-mz.122-15.T15.bin"

cisco 2610 (MPC860) processor (revision 0x202) with 61440K/4096K bytes of 
memory.
Processor board ID JAB032107RG (964249776)
M860 processor: part number 0, mask 49
Bridging software.
X.25 software, Version 3.0.0.
TN3270 Emulation software.
1 Ethernet/IEEE 802.3 interface(s)
1 Serial network interface(s)
32K bytes of non-volatile configuration memory.
16384K bytes of processor board System flash (Read/Write)

xxxxx.gw#sho int desc
Interface                      Status         Protocol Description
Et0/0                          up             up
Et0/0.1                        up             up
Et0/0.412                      up             up       Management-Net
Et0/0.414                      up             up       Print-Srvrs
Et0/0.415                      up             up       Workstations




More information about the cisco-nsp mailing list