[c-nsp] 7200 PPPoE disconnecting users

[Brian Lehigh]

Matt,
You're looking for a manual way to terminate a session?  Issue a "show user"
and get the interface number (should be Vix.x).  You should then be able to
issue a "clear int vix.x".
i.e.
---------------------
rt-broadband-00#sh user
  Interface    User               Mode         Idle     Peer Address
  Vi1.1        dsluser           PPPoE         00:00:03 xxx.xxx.218.5

rt-broadband-00#clear int vi1.1
---------------------

Hope that helps.

Brian Lehigh
Network Operations Center
Sierra Tel Internet
http://www.sti.net
 

-----Original Message-----
From: cisco-nsp-bounces at puck.nether.net
[mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of Matt Addison
Sent: Monday, August 22, 2005 4:24 PM
To: cisco-nsp at puck.nether.net
Subject: [c-nsp] 7200 PPPoE disconnecting users

Anyone know a way to disconnect PPPoE users from a 7200 configured to
terminate PPPoE sessions? Preferably over the console although known
methods using RADIUS/SNMP would also be welcomed. Not finding anything
about doing this on Google so far...

Note, this is not for automatic session/idle disconnects, looking for a
way the provider can initiate a disconnect of a user.

Using "IOS (tm) 7200 Software (C7200-IK9S-M), Version 12.2(31), RELEASE
SOFTWARE (fc2)"

Thanks in advance,
~Matt

_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/