[c-nsp] Export from VRF into global route table

McCallum, Robert robert.mccallum at thus.net
Fri Feb 4 09:00:15 EST 2005


> -----Original Message-----
> From: Oliver Boehmer (oboehmer) [mailto:oboehmer at cisco.com] 
> Sent: 04 February 2005 13:56
> To: Joe Maimon
> Cc: Pete Kruckenberg; cisco-nsp at puck.nether.net
> Subject: RE: [c-nsp] Export from VRF into global route table
> 
> 
> 
> >>> I hope this is a stupid question, because I'd sooner find 
> out that 
> >>> I'm missing something, than find out that I can't do this.
> >>> 
> >>> Is there a way to export routes from a VRF into the global table 
> >>> (GSR 12404/PRP2 running 12.0.30S)?
> >> 
> >> You can only do this manually, i.e. static global routes 
> pointing to 
> >> the vrf interface:
> >> 
> >> int serial0
> >> ip vrf forwarding foo
> >> ...
> >> !
> >> ip route <prefix> <mask> serial0
> >> 
> >
> > Will this work for non point-to-point interfaces?
> 
> it works (tested 12.3(10)) when I do "ip route <prefix> 
> <mask> ethernet0 <next-hop>", but not sure if it's supported.

When the question rose on the netpro forum I tried to redistribute vrf
routes
into the global routing table using ospf, bgp, eigrp and nowt worked.  So
static
it might be but very much doubt that's supported.

> 
> 	oli
> 
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net 
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
> 


More information about the cisco-nsp mailing list