[c-nsp] 7600 does not boot 12.2

[Tim Winders]

Reformat the flash card and reload the image to the card.  After you load 
it, check the sum on it to make sure it matches that shown on the cisco 
website.

--

Tim Winders
Associate Dean of Information Technology
South Plains College
Levelland, TX 79336

On Mon, 17 Jan 2005, Konstantin Barinov wrote:

>
> Hi again 7600/6500 gurus,
>
>
> 7603 does not want to boot 12.2, but 12.1 loads and works fine.
>
> config is:
>
> boot system flash disk0:c6k222-ps-mz.122-18.SXD3.bin
> boot system flash sup-bootflash:c6sup22-ps-mz.121-26.E.bin
>
>
> While booting, router shows error message below, and continues
> with 12.1 from sup-bootflash fine.
>
> Flash card is ok, checked in another device.
>
>
> System Bootstrap, Version 7.1(1)
> Copyright (c) 1994-2001 by cisco Systems, Inc.
> c6k_sup2 processor with 262144 Kbytes of main memory
>
> Autoboot executing command: "boot disk0:c6k222-ps-mz.122-18.SXD3.bin"
>
> *** TLB (Store) Exception ***
> Access address = 0x10000403
> PC = 0x80010978, Cause = 0xc, Status Reg = 0x30419003
>
> monitor: command "boot" aborted due to exception.
>
>
>
> Thanks in advance for help!
>
>
>
>
>
> br
> --
> Konstantin Barinov
> INFONET AS, Tallinn, Estonia
>
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>