[c-nsp] Trying to get an ATM ciruit up

[MADMAN]

   You can also try looping the coax tx - rx.  You may have to change 
the timing to internal.

   dave





Dave Temkin wrote:
> Do you get the RXCLK light coming on?
> 
> If not, it's a physical cabling issue.
> 
> -Dave
> 
> On Thu, 20 Jan 2005, Voll, Scott wrote:
> 
> 
>>Can anyone give me a hit as to what I'm doing wrong?
>>
>>I'm trying to bring up an ATM DS3 and I'm getting Rx loss.
>>
>>My config is below.  Am I missing more configurations?
>>
>>interface ATM4/0/0
>> no ip address
>>!
>>!
>>interface ATM4/0/0.33 point-to-point
>> description XXXXXX
>> ip address xxx.xxx.xxx.xxx 255.255.255.252
>> pvc 1/33
>>  vbr-nrt 1024 1024
>>  encapsulation aal5snap
>>
>>This is a FR to ATM configuration using a CAT 6509 flexwan / ATM DS3
>>Card (enhanced).
>>
>>Telco is pointing finger my way.  Do I need to setup Controller in
>>global config?
>>
>>TIA
>>
>>Scott
>>_______________________________________________
>>cisco-nsp mailing list  cisco-nsp at puck.nether.net
>>https://puck.nether.net/mailman/listinfo/cisco-nsp
>>archive at http://puck.nether.net/pipermail/cisco-nsp/
>>
> 
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
> 

-- 
David Madland
CCIE# 2016
Sr. Network Engineer
Qwest Communications
612-664-3367

"Emotion should reflect reason not guide it"