[c-nsp] Trying to get an ATM ciruit up

[MADMAN]

   How about "atm scrambling cell-payload"

   Dave

Voll, Scott wrote:

> Loop back the alarm and cell go off but I have a green enable and
> carrier.
> 
> -----Original Message-----
> From: MADMAN [mailto:david.madland at qwest.com] 
> Sent: Thursday, January 20, 2005 1:05 PM
> To: Dave Temkin
> Cc: Voll, Scott; cisco-nsp at puck.nether.net
> Subject: Re: [c-nsp] Trying to get an ATM ciruit up
> 
> 
> 
>    You can also try looping the coax tx - rx.  You may have to change 
> the timing to internal.
> 
>    dave
> 
> 
> 
> 
> 
> Dave Temkin wrote:
> 
>>Do you get the RXCLK light coming on?
>>
>>If not, it's a physical cabling issue.
>>
>>-Dave
>>
>>On Thu, 20 Jan 2005, Voll, Scott wrote:
>>
>>
>>
>>>Can anyone give me a hit as to what I'm doing wrong?
>>>
>>>I'm trying to bring up an ATM DS3 and I'm getting Rx loss.
>>>
>>>My config is below.  Am I missing more configurations?
>>>
>>>interface ATM4/0/0
>>>no ip address
>>>!
>>>!
>>>interface ATM4/0/0.33 point-to-point
>>>description XXXXXX
>>>ip address xxx.xxx.xxx.xxx 255.255.255.252
>>>pvc 1/33
>>> vbr-nrt 1024 1024
>>> encapsulation aal5snap
>>>
>>>This is a FR to ATM configuration using a CAT 6509 flexwan / ATM DS3
>>>Card (enhanced).
>>>
>>>Telco is pointing finger my way.  Do I need to setup Controller in
>>>global config?
>>>
>>>TIA
>>>
>>>Scott
>>>_______________________________________________
>>>cisco-nsp mailing list  cisco-nsp at puck.nether.net
>>>https://puck.nether.net/mailman/listinfo/cisco-nsp
>>>archive at http://puck.nether.net/pipermail/cisco-nsp/
>>>
>>
>>_______________________________________________
>>cisco-nsp mailing list  cisco-nsp at puck.nether.net
>>https://puck.nether.net/mailman/listinfo/cisco-nsp
>>archive at http://puck.nether.net/pipermail/cisco-nsp/
>>
> 
> 

-- 
David Madland
CCIE# 2016
Sr. Network Engineer
Qwest Communications
612-664-3367

"Emotion should reflect reason not guide it"