[c-nsp] 2811 router doesn't recognize T-1 WICs?

Jay Hennigan jay at west.net
Mon Jan 24 20:17:25 EST 2005


Hello fellow Cisco-NSP folk.

I have a brand new 2811 router which according to the Cisco DPRG
configurator is supposed to take the WIC-1DSU-T1-V2 modular WICs
as opposed to the non-V2 type.

So we paid the higher price for brand-spanking-new V2 modules, and they
don't show up.  "sho diag" gives:

        WIC Slot 0:
        Unknown WAN daughter card
        WIC module not supported/disabled in this slot
        Hardware revision 64.0          Board revision >1
        Serial number     1379991808    Part number    800-7441222-79
        Test history      0x43          RMA number     48-55-51
        Connector type    PCI
        EEPROM format version 1
        EEPROM contents (hex):
          0x20: 01 80 40 00 52 41 01 00 C1 8B 46 4F 43 30 37 33
          0x30: 31 31 41 36 4A 82 49 20 9A 03 42 41 30 03 00 81

Tried two different WICs in all slots with similar results.

Is there some magic needed to get these recognized or do I have a hardware
issue?  The box is running IP-Base 12.3(11)T2, same results with 12.3(8)T.

--
Jay Hennigan - CCIE #7880 - Network Administration - jay at west.net
WestNet:  Connecting you to the planet.  805 884-6323      WB6RDV
NetLojix Communications, Inc.  -  http://www.netlojix.com/


More information about the cisco-nsp mailing list