[c-nsp] Standby Sup2/MSFC2 on 7609

[Michael Axelrod]

Did you try commands:
"session 16"
or  "switch console 16" - this should switch the console port on standby SUP
Mike. 
----- Original Message ----- 
From: "Ryan" <rlandry at tac.net>
To: <cisco-nsp at puck.nether.net>
Sent: Friday, January 28, 2005 10:14 AM
Subject: [c-nsp] Standby Sup2/MSFC2 on 7609


> i'm curious if anyone knows of a way to remotely check the memory levels of a
> standby msfc2 on a c7609 running IOS 12.1(13)E15.  i can get the active and
> standby sup2 with the usual 'sh ver' and 'remote comm switch sh ver' or 'attach'
> type of stuff, but can only get the active msfc2.  can't seem to find any
> 'backdoor' ways other than pulling the card out and having a peek (and even then
> it is somewhat hard to identify the chip).  didn't find much on cisco's site.
> 
> so, other than performing a redundancy switch, any ideas would be greatly
> appreciated.
> 
> cheers
> 
> -ryan
> 
> 
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/