[c-nsp] bridging continued

[Scott Granados]

I missed the bridge-group for Ethernet 1

Ok I think I may have missed a bridge-group in my serials I'll try that.


-----Original Message-----
From: Michael Costello [mailto:michael.costello at gmail.com] 
Sent: Monday, June 20, 2005 2:05 PM
To: Scott Granados
Cc: cisco-nsp at puck.nether.net
Subject: Re: [c-nsp] bridging continued

On 20/06/05, Scott Granados <scott at jeteye.com> wrote:
> Hmmm, still no go here's what I have I think I got this right.
> 
> Globally
> Bridge irb
> Bridge 1 protocol ieee
> Bridge 1 route ip
> Int eth 0
> No ip addr
> Int bvi 1
> Ip addr 10.0.1.251 255.255.255.0
> No shutdown
> 
> Same on other router but 10.0.1.252 in bvi interface
> Can't ping from one bvi to the other.
>
> 
> What do I do with the serials just put them in the bridge group?

Yes.  You're not going to be able to ping the other router's BVI IP
unless you bridge together the interfaces that connect the routers.

And in this configuration, it doesn't appear that Ethernet 0 is
configured to be a part of bridge-group 1.