[c-nsp] Thanks for the help. crossover ain't working. Tried it.

[MADMAN]

   Make sure the L3 port you are using is an L2, switchport, on the same 
VLAN as the L2 switch your trying to connect to.  Or as suggested by 
Scott if it is a trunk you need something like this on both ends:

interface GigabitEthernet5/2
  no ip address
  switchport
  switchport trunk encapsulation dot1q
  switchport mode trunk

   Dave

Joe Gilliam wrote:

> OK, thanks again for the help.
>  
> I tried to use the crossover.  It didn't work.  I am connecting to the L3 just like I was to the 2948G.  This one don't like it.  SO I can't figure out why it isn't connecting.  I have probably got something wrong on port 47.  
>  
> What should I check for?  There is not an IP address configured for that port.  I am watching the console and the interfaces come up and down like they should.
>  
> It's probably something stupid I did.  
>  
> any Ideas?  
>  
> Thanks again for the help.
>  
> Joe Gilliam
> 
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
> 
> 

-- 
David Madland
CCIE# 2016
Sr. Network Engineer
Qwest Communications
612-664-3367

"Emotion should reflect reason not guide it"