[c-nsp] 3620 boot issue - no rommon

[nick.nauwelaerts at thomson.com]

Hello,
I've got a Cisco 3620 here on which I needed to load a new image &
config. So I erased the config with a "write erase" & removed the IOS
file from the onboard flash. After that I issued a reload on the unit,
without loading a new IOS image on the internal flash (I had one on a
flash card which I was hoping to boot from rommon).

After the reload the unit didn't come back up again - nothing on the
console either. It just keeps blinking it's system led. To make sure the
console was set up correctly I did a reset of the console speed with the
onboard jumper, but still nothing. At 9600 baud the console remains
dead, nor does it answer any break sequences sent.

Any clues what I can still try? I have some spare routers if need be
(3660 & some 2600's).

Thanks.

// nick