[c-nsp] 6500 SUP720 High Latency and Jitter issues

[Dan Benson]

As you can all understand here, I am well part of this learning curve, 
and I appreciate your help.  What I have learned at this point is the 
following:

In order for the tunnels to be hardware switched, I must use a unique IP 
for the Source and destination, in this case a separate Loopback on both 
ends seems to be perfect.  This I have never read in any documentation, 
either it is not there, or it is and I did not read it.  I am sure it is 
the latter.  I will say that the router only warns you once about the 
packets being software switched per unique IP, if I add 3 tunnels using 
the same source IP, the router will only tell me after the 2nd, and not 
the third.  This is why I was being baffled.

As for myself not knowing my platform, I consider all of this learning 
my platform, and hopefully giving others access to the things I am 
experiencing.  I have very in-depth knowledge of the 2500 up to the 
12000, but I will admit this platform is a bit new to me, and it is 
being deployed in a fast moving environment, so please excuse me for not 
reading all of the millions of docs out there, I just haven't the time.  

Again, thanks much for all the feedback, I would have been dead without 
it.  //db