[c-nsp] Cisco 3750, upgrading from SEC2 to SED

[Ed Butler - RapidSwitch]

We have tried this on three switches, all with the same results:
WS-C3750G-24T-S
WS-C3750G-24T-E
WS-C3750G-24TS-S

Upgrading from SEC2 to SED (on ipbase or ipservices image) runs fine.
However, when we reboot the switches into the new IOS and run the following
test, we get errors:

Switch#fsck /test flash:

Fsck operation may take a while. Continue? [confirm]

i28f128j3_16x_write_bytes: command sequence error

flashfs[1]: writing to flash handle 0x26DBFE0, device 0, offset 0x400000,
length

: 0x20: Operation Failed

%Error fscking flash:: (I/O error)


Has anyone seen similar results?

Regards,

Ed Butler
RapidSwitch Ltd
DDI: 020 7106 0731

RapidSwitch Ltd, 5th Floor, Sovereign House, 227 Marsh Wall, London, E14 9SD

This email message is intended only for the addressee(s) and contains
information that may be confidential and/or copyright.  If you are not the
intended recipient please notify the sender by reply email and immediately
delete this email. Use, disclosure or reproduction of this email by anyone
other than the intended recipient(s) is strictly prohibited. No
representation is made that this email or any attachments are free of
viruses. Virus scanning is recommended and is the responsibility of the
recipient.