[c-nsp] MPLS for Sup720-3BXL / IOS feature set

[Roman Sokolov]

Hello Chris,

Thursday, November 10, 2005, 10:05:47 PM, you wrote:
CG> I believe "IP" went away after SXD (which was the small one).
Right. But i'm sure Kristofer just want image as small as possible :)

CG> SXE and later give you IPservices or Advanced IPservices.  Both large...
There is images with wan code included (extra-large) and without it
(much smaller, lan-only). It could be found in CAT6000(Sup720/MSFC3)
section of software center.

CG> Roman Sokolov wrote:
>> Hello Kristofer,
>> 
>> Yes, it support mpls perfectly. Even more, if you don't need support for
>> wan cards (osm, sip etc.) then you can run s72033-ipservicesk9-mz.122-18.SX*.bin.
>> It's about 2 times smaller, so why keeping unnided modules?
>> Also i would recommend you use SXE-latest or try luck at SXF.
>> 
>> Thursday, November 10, 2005, 4:23:08 PM, you wrote:
>> 
>> KS> Ahh, the change from "IP" to "IP Services"?  Thanks for the info, Rich.
>> 
>> KS> According to these release notes, MPLS is not supported in the IP 
>> KS> feature set, but according to the feature navigator, they are.
>> 
>> KS> Can anyone confirm or deny MPLS support in 12.2(18)SXD6 on Sup720-3BXL,
>> KS> using the IP feature set?
>> 
>> KS> On Thu, 2005-11-10 at 23:05 +1100, Richard Gallagher wrote:
>> 
>>>>The feature sets for 12.2SX changed in SXE with the new ios packaging. 
>>>>You can compare the 2 different feature set schemes in the release notes:
>>>>
>>>>http://www.cisco.com/en/US/products/hw/switches/ps708/prod_release_note09186a00801c8339.html#wp1840752
>>>>
>>>>Rich
>>>>
>>>>Kristofer Sigurdsson wrote:
>>>>
>>>>>Hi,
>>>>>
>>>>>I've been looking into doing MPLS on a 7600/Sup720-3BXL and
>>>>>wondering which IOS I should use.  According to the feature
>>>>>navigator, IOS 12.2(18)SXD supports MPLS in the basic IP
>>>>>feature set, but 12.2(18)SXF ("IP Services") does not.
>>>>>Now, I was under the impression that SXF was simply a later
>>>>>release of SXD...so they should support the same features?
>>>>>
>>>>>Is anyone running MPLS on this hardware using the normal "IP"
>>>>>feature set in 12.2SXD?  Any advice on how to proceed in this?
>>>>>Is MPLS support in the basic feature set on SXD something that
>>>>>will be removed from later releases?
>>>>>
>>>>>Thanks in advance,
>>>>>-Kristofer
>>>>>_______________________________________________
>>>>>cisco-nsp mailing list  cisco-nsp at puck.nether.net
>>>>>https://puck.nether.net/mailman/listinfo/cisco-nsp
>>>>>archive at http://puck.nether.net/pipermail/cisco-nsp/
>> 
>> KS> _______________________________________________
>> KS> cisco-nsp mailing list  cisco-nsp at puck.nether.net
>> KS> https://puck.nether.net/mailman/listinfo/cisco-nsp
>> KS> archive at http://puck.nether.net/pipermail/cisco-nsp/
>> 



-- 
Best regards,
 Roman
 mailto:rps at cheater.ru

... Good products - Бог на стороне уток ...