[c-nsp] 3640 console issue

[Serge Vondandamo]

Hi,

I use a Baud reset Jumper in the 3640 motherboard and placed it in a different field that allowed me to boot to rommon and reloaded the router without using the startup conf.
So, I am back on the router again :)
What I don’t understand is this: why an NM-2V module will change the console baud settings of the router, any clues? And it is a physical change not software since I have tried all the settings on HyperTerminal.

Now, I will try to install the NM-2V module again and see what will happen.

Regards
Serge

-----Original Message-----
From: cisco-nsp-bounces at puck.nether.net [mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of Serge Vondandamo
Sent: samedi 1 octobre 2005 12:57
To: cisco-nsp at puck.nether.net
Subject: [c-nsp] 3640 console issue

Hi Guys,

I have inserted an NM-2V module on 3640 running 12.3 plus image. When I boot the device, the console displays only garbage. I can't ping any interface on the router. I tried changing different console cables and console settings but no luck; I can't get to the router.

I have removed all modules on the router and also removed the flash to try to boot on rommon but no luck either, it only displays the bellow garbage:

¶JŸô ÷ ww÷÷w÷




                                                    þАÛóóh°˜öû

Has anyone ever seen this? 

Thanks
Serge




_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/