[c-nsp] Sub-Interface Support 122.25.SEC 3750

[Alex Foster]

I Posted this a couple of days ago - and didn't get any feedback - so
was just wondering if the Cisco guys on the list are aware of this - and
whether they have workarounds in place or a fix - I really need the use
of VRF with Sub-Interfaces - which would only be available in the SEC
release - except for some reason the ability to configure Sub-interfaces
isn't there.....

The response you get from the switch is ....

Switch (config)#int gigabitEthernet 1/0/10.100
                               ^
% Invalid input detected at '^' marker.


"Strange one this, not sure if its been done on purpose or whether the
software guys have left it out by mistake - but it appears as though
122-25.SEC for the 3750 doesn't support sub-interfaces - 122.25.SEB did,
but I upgraded to SEC for VRF functionality and found I couldn't create
sub-interfaces - rolled back to SEB and there you have it (but no VRF,
obviously).  Can anyone comment - or I have missed the boat and someones
decided that this feature is no longer of any use to anyone..."

Any help with this would be appreciated .... Regards

Alex


The information in this e-mail and any attachments is confidential and may be subject to legal professional privilege. It is intended solely for the attention and use of the named addressee(s). If you are not the intended recipient, or person responsible for delivering this information to the intended recipient, please notify the sender immediately. Unless you are the intended recipient or his/her representative you are prohibited from, and therefore must not, read, copy, distribute, use or retain this message or any part of it. The views expressed in this e-mail may not represent those of Gamma Telecom.

This message has been scanned for viruses by MailController