[c-nsp] 7600 switchover

[Kim Onnel]

right, i dont have these configus, thats why i have RPR mode enabled not 
RPR+

So i will need to configure them, upgrade IOS, do i need to reload any 
module or the whole chassis afterwards ?

On 9/6/05, Andrew Fort <afort at choqolat.org> wrote:
> 
> Kim Onnel wrote:
> > Is there specific configuration needed or is it by default to have RPR+
> > established,
> 
> you'll need something along the lines of...
> 
> !
> redundancy
> mode rpr-plus
> main-cpu
> auto-sync running-config
> auto-sync config-register
> auto-sync bootvar
> auto-sync standard
> !
> 
> > Also, what if i am using the Gig. interface on the standby module, would
> > that break RPR+ ?
> 
> no, it won't break RPR+ (you can use the interfaces on the standby
> module if it is not in a failure state).


How do i determine if they are active or failed, if i remember correctly, 
they should be Active ?


-andrew
>