[c-nsp] Disabling autosense?

[Xavier Mertens]

Hi *,

Maybe a dummy question but...
I've a Catalyst 4506 (IOS 12.2(18)EW) and a port:

interface GigabitEthernet2/37
 description TEST
 speed 1000
 duplex full

How can I be *sure* that the port is fixed to 1000/FD?
A 'sh int gigabitEthernet 2/37' reports:

GigabitEthernet2/37 is down, line protocol is down (notconnect)
  Hardware is Gigabit Ethernet Port, address is 0011.bbf7.c804 (bia 0011.bbf7.c804)
  Description: TEST
  MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
     reliability 255/255, txload 1/255, rxload 1/255
  Encapsulation ARPA, loopback not set
  Keepalive set (10 sec)
  Auto-duplex, Auto-speed, link type is auto, media type is 10/100/1000-TX
  input flow-control is off, output flow-control is off
  ARP type: ARPA, ARP Timeout 04:00:00
  Last input never, output never, output hang never
  Last clearing of "show interface" counters never
  Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 0
  Queueing strategy: fifo
  Output queue: 0/40 (size/max)
  5 minute input rate 0 bits/sec, 0 packets/sec
  5 minute output rate 0 bits/sec, 0 packets/sec
     45244 packets input, 4530310 bytes, 0 no buffer
     Received 12 broadcasts (0 multicast)
     0 runts, 0 giants, 0 throttles
     0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
     0 input packets with dribble condition detected
     31121117 packets output, 42046678421 bytes, 0 underruns
     0 output errors, 0 collisions, 0 interface resets
     0 babbles, 0 late collision, 0 deferred
     0 lost carrier, 0 no carrier
     0 output buffer failures, 0 output buffers swapped out

Regards,
Xavier
--
> SELECT * FROM users WHERE clue > 0;
0 rows returned