[c-nsp] Re: Enable privilege settings

[Kanagaraj Krishna]

Hi,
   I've realised that in Cisco's enable privilege settings, the user can only 
view the config (interface, routing protocol etc) under "sh run" only if they 
are permitted to edit those configurations. In Juniper for example, they have 
two options for each category of config (Example: "View interface config only" 
and "Edit interface config"). This enables user to view the needed config 
without being able to edit. Any suggestions of doing this in Cisco. Examples 
would be helpful. Thanks

Regards,
Kanagaraj Krishna