[c-nsp] router boot prompt

[Rodney Dunn]

Post the full bootup sequence.
Make sure you have a valid image on your PCMCIA card or flash disk.
Remove all other files from bootflash other than your -boot- image.
Remove all boot statements from your config.
Make sure your config-register is 0x2102.

...

If that doesn't work hit it with a bit fat hammer. :)

Rodney


On Mon, Jun 26, 2006 at 04:45:26PM -0500, Chad Whitten wrote:
> ive had this happen once before but it was ages ago and i cant remember
> what i did to fix it.  when my 7206 boots up, i get a prompt like
> router(boot)#
> i can go into enable mode, config interfaces, etc, but im not using the
> router till i get this worked out.  can anyone point me to what i need to
> do to get to a normal prompt?
> 
> 
> -- 
> Chad Whitten
> 
> 
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/