[c-nsp] atm0 going down every five minutes (DSL: Defect: LOS LOF LCDi: retraining)
Marko Milivojevic
markom at pangalactic.net
Thu Jun 29 12:17:37 EDT 2006
You don't have another Cisco to try out?
Elmar Pigeaud wrote:
> Hm... too late to ask them now. Workday's been over for aaaages (6:15) ;-)
>
> Can you think of anything else?
>
> Thanks, however.
>
> On 6/29/06, *Marko Milivojevic * <markom at pangalactic.net
> <mailto:markom at pangalactic.net>> wrote:
>
>
> I believe that you can't set it from your side (I could be wrong, I
> don't
> have any routers now that I can play with), but you could ask service
> provider to lower it. 8 Mb/s downstream may not be the real problem, it
> could be related to the upstream speed. 4M/512K should work for up
> to 3 km
> over sewer pipes ;-)
>
> Elmar Pigeaud wrote:
> > Sorry for asking, but how can I lower the speed?
> >
> > Thanks!
> >
> > On 6/29/06, *Marko Milivojevic* <markom at pangalactic.net
> <mailto:markom at pangalactic.net>
> > <mailto:markom at pangalactic.net <mailto:markom at pangalactic.net>>>
> wrote:
> >
> >
> > Try lowering the speed. I had problems with some 827's at 8 Mb/s
> > even with
> > rather short lines (~300m).
> >
> > Elmar Pigeaud wrote:
> > > Called them, they tested the line: no problem (they never
> heard
> > of SELT
> > > however). Other modems have no problem whatsoever (can't
> try another
> > > cisco...). The line should be very short, because it is
> connected
> > in our
> > > own street and I get the full 8mbit.
> > >
> > > I can try to have them test the line more than they did
> now, but as
> > > other modems have no problem on the same line, I don't
> think the
> > > solution will be there.
> > >
> > > Any other suggestions?
> > >
> > > On 6/29/06, *Marko Milivojevic* <markom at pangalactic.net
> <mailto:markom at pangalactic.net>
> > <mailto: markom at pangalactic.net <mailto:markom at pangalactic.net>>
> > > <mailto:markom at pangalactic.net
> <mailto:markom at pangalactic.net> <mailto:markom at pangalactic.net
> <mailto:markom at pangalactic.net>>>>
> > wrote:
> > >
> > >
> > > How long is the line? Can you ask the operator to
> perform SELT on
> > > the line?
> > >
> > > Elmar Pigeaud wrote:
> > > > Sorry to re-submit the question, however, I got
> somewhat
> > further.
> > > Our c836
> > > > router loses connection every five minutes. The
> line is
> > ok, other
> > > modems
> > > > work fine. Our provider can see no problem. Can
> this have
> > > something to do
> > > > with my config? At the moment it is still very
> simple, and
> > I have
> > > never
> > > > encountered a similar problem with the same provider.
> > > >
> > > > Has anyone ever seen a similar problem?
> > > >
> > > > Thanks in advance!
> > > >
> > > > Pjn
> > > >
> > > > The log:
> > > >
> > > > Jun 29 14:33:51.750: DSL: Defect: LOS LOF LCDi:
> retraining
> > > > Jun 29 14:33:51.750: DSL: Received response: 0x41
> > > > Jun 29 14:33:52.710:
> c820_atm_check_linkstate_periodic:
> > PHY line
> > > is going
> > > > down
> > > > Jun 29 14:33: 52.710: Shutting down ATM0...
> > > > Jun 29 14:33:52.710: ATM0 c820_atm_shutdown: state=0
> > > > Jun 29 14:33:52.710: pquicc_sar_stop...
> > > > Jun 29 14:33:52.710: c820_atm_stop_receive...
> > > > Jun 29 14:33:52.966: pquicc_sar_rx_disable...
> > > > Jun 29 14:33:52.966: Disable TX Cav ....
> > > > Jun 29 14:33:52.966: Disable RX Cav ....
> > > > Jun 29 14:33:52.966 : Disable PD[15] and PD[14] ....
> > > > Jun 29 14:33:52.970: c820_reset_vc: conid = 0
> > > > Jun 29 14:33:52.970: c820_reset_vc: conid = 3
> > > > Jun 29 14:33:52.970: Resetting ATM0
> > > >
> > > > Firmware info:
> > > >
> > > > Cisco IOS Software, C836 Software (C836-K9O3Y6-M),
> Version
> > > 12.3(8)T11,
> > > > RELEASE S
> > > > OFTWARE (fc1)
> > > > Technical Support: http://www.cisco.com/techsupport
> > > > Copyright (c) 1986-2005 by Cisco Systems, Inc.
> > > > Compiled Wed 10-Aug-05 20:25 by dchih
> > > >
> > > > ROM: System Bootstrap, Version 12.2(11r)YV3, RELEASE
> > SOFTWARE (fc2)
> > > >
> > > > gw2 uptime is 2 hours, 52 minutes
> > > > System returned to ROM by power-on
> > > > System restarted at 11:48:51 UTC Thu Jun 29 2006
> > > > System image file is "flash:
> c836-k9o3y6-mz.123-8.T11.bin"
> > > >
> > > > Running config:
> > > >
> > > > !
> > > > ! Last configuration change at 13:07:35 UTC Thu Jun 29
> > 2006 by admin
> > > > !
> > > > version 12.3
> > > > no service pad
> > > > service timestamps debug datetime msec
> > > > service timestamps log datetime msec
> > > > no service password-encryption
> > > > !
> > > > hostname c836
> > > > !
> > > > boot-start-marker
> > > > boot-end-marker
> > > > !
> > > > logging buffered 10000 debugging
> > > > no logging console
> > > > !
> > > > no aaa new-model
> > > > ip subnet-zero
> > > > !
> > > > !
> > > > ip ips po max-events 100
> > > > no ftp-server write-enable
> > > > !
> > > > !
> > > > username admin privilege 15 secret 5 <pw>
> > > > !
> > > > !
> > > > bridge irb
> > > > !
> > > > !
> > > > interface Ethernet0
> > > > description
> $ETH-LAN$$ETH-SW-LAUNCH$$INTF-INFO-Ethernet
> > 10/100$
> > > > ip address 192.168.20.1 <http://192.168.20.1>
> <http://192.168.20.1>
> > <http://192.168.20.1> 255.255.255.0 <http://255.255.255.0> <
> http://255.255.255.0>
> > > <http://255.255.255.0>
> > > > ip nat inside
> > > > !
> > > > interface BRI0
> > > > no ip address
> > > > shutdown
> > > > !
> > > > interface ATM0
> > > > no ip address
> > > > no ip route-cache
> > > > no ip mroute-cache
> > > > no atm ilmi-keepalive
> > > > dsl operating-mode auto
> > > > dsl enable-training-log
> > > > bridge-group 1
> > > > bridge-group 1 spanning-disabled
> > > > pvc auto 0/34
> > > > encapsulation aal5snap
> > > > !
> > > > !
> > > > interface FastEthernet1
> > > > no ip address
> > > > duplex auto
> > > > speed auto
> > > > !
> > > > interface FastEthernet2
> > > > no ip address
> > > > duplex auto
> > > > speed auto
> > > > !
> > > > interface FastEthernet3
> > > > no ip address
> > > > duplex auto
> > > > speed auto
> > > > !
> > > > interface FastEthernet4
> > > > no ip address
> > > > duplex auto
> > > > speed auto
> > > > !
> > > > interface BVI1
> > > > mac-address 000f.fe1e.f0a5
> > > > ip address dhcp
> > > > ip nat outside
> > > > !
> > > > ip classless
> > > > ip route 0.0.0.0 <http://0.0.0.0> <http://0.0.0.0>
> < http://0.0.0.0> 0.0.0.0 <http://0.0.0.0>
> > <http://0.0.0.0> <http://0.0.0.0> BVI1
> > > > no ip http server
> > > > ip nat inside source list 1 interface BVI1 overload
> > > > !
> > > > !
> > > > access-list 1 permit 192.0.0.0 <http://192.0.0.0>
> <http://192.0.0.0>
> > <http://192.0.0.0> 0.255.255.255 <http://0.255.255.255>
> <http://0.255.255.255 <http://0.255.255.255>>
> > > <http://0.255.255.255>
> > > > !
> > > > control-plane
> > > > !
> > > > bridge 1 protocol ieee
> > > > bridge 1 route ip
> > > > !
> > > > line con 0
> > > > login local
> > > > no modem enable
> > > > line aux 0
> > > > line vty 0 4
> > > > privilege level 15
> > > > login local
> > > > transport input telnet ssh
> > > > !
> > > > scheduler max-task-time 5000
> > > > !
> > > > end
> > > > _______________________________________________
> > > > cisco-nsp mailing list cisco-nsp at puck.nether.net
> <mailto:cisco-nsp at puck.nether.net>
> > <mailto:cisco-nsp at puck.nether.net
> <mailto:cisco-nsp at puck.nether.net>>
> > > <mailto:cisco-nsp at puck.nether.net
> <mailto:cisco-nsp at puck.nether.net>
> > <mailto:cisco-nsp at puck.nether.net
> <mailto:cisco-nsp at puck.nether.net>>>
> > > > https://puck.nether.net/mailman/listinfo/cisco-nsp
> <https://puck.nether.net/mailman/listinfo/cisco-nsp>
> > > <https://puck.nether.net/mailman/listinfo/cisco-nsp
> > < https://puck.nether.net/mailman/listinfo/cisco-nsp>>
> > > > archive at http://puck.nether.net/pipermail/cisco-nsp/
> > > >
> > >
> > >
> >
> >
>
>
More information about the cisco-nsp
mailing list