[c-nsp] jumbo frames

[Dave Temkin]

Not sure either - I'm talking about doing it on SVI's, not if you do a no
switchport on an interface... I'll have to try that..

-Dave

On Sat, 4 Mar 2006, Gert Doering wrote:

> Hi,
>
> On Sat, Mar 04, 2006 at 09:06:10AM -0500, Dave Temkin wrote:
> > > Unfortunately, at least on some 35xx switches (I don't remember the specific
> > > model nor the IOS version - it was at a customer's site, and I no longer
> > > have access to the devices), this does not seem to be possible - there
> > > is only a global L3 MTU value, and it is automatically applied to ALL
> > > L3 interfaces.  Which sucks.
> >
> > Correct, however on those platforms you just use the "ip mtu" command to
> > lower it down and then it's not a problem (the mtu interface command
> > doesn't work).
>
> As far as I remember, there was no "ip mtu" command on a per-interface
> basis - but maybe that was due to "switchport" still being in effect.
>
> Thanks for that hint, I need to re-check that with the affected customer.
>
> gert
>
>