[c-nsp] Problems sub-interface Catalyst 6500

[Jared Mauch]

On Fri, May 05, 2006 at 12:20:45PM -0500, Alexandra Alvarado wrote:
> Hello,
> 
>  
> 
> I would like to know if It's possible to add the same vlan id on two
> different interfaces, I am using a Catalyst 6500 switch (Version
> 12.2(18)SXD6).  The question is because if I try to add encapsulation dot1q
> 2 on a sub-interface that belong to another interface, I get the following
> error:

	Upgrade to SXF4 and that should help.

> 
>  
> 
> interface GigabitEthernet7/1
> 
>  description 3550-S1
> 
>  mtu 9216
> 
>  no ip address
> 
>  no ip proxy-arp
> 
>  
> 
> interface GigabitEthernet7/1.1
> 
>  encapsulation dot1Q 2
> 
>  ip vrf forwarding VRF00001
> 
>  ip address 10.201.15.254 255.255.255.252
> 
>  
> 
> interface GigabitEthernet7/2
> 
>  description 3550-S2
> 
>  mtu 9216
> 
>  no ip address
> 
>  no ip proxy-arp
> 
>  
> 
> TELEPUERTO#config term
> 
> TELEPUERTO(config)#interface gigabitEthernet 7/2.1
> 
> TELEPUERTO(config-subif)# ip vrf forwarding VRF00001
> 
> TELEPUERTO(config-subif)#encapsulation dot1Q 2
> 
> Command rejected: VLAN 2 not available
> 
> TELEPUERTO(config-subif)#
> 
>  
> 
>  
> 
> Thanks
> 
>  
> 
> A.A.A.A.
> 
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/

-- 
Jared Mauch  | pgp key available via finger from jared at puck.nether.net
clue++;      | http://puck.nether.net/~jared/  My statements are only mine.