[c-nsp] WS-X5410 issue

[Corneliu Tanasa]

Thanks, but the module is inserted according to table 7 from the document,
meaning slots 4-5.  Might this be a hardware or software issue ?  might be
involved the 5410 card, backplane or supervisor (it is a SupIII w/ NFFC-2A)?

Corneliu Tanasa

-----Original Message-----
From: Sean Granger [mailto:sgranger at randfinancial.com] 
Sent: Saturday, May 06, 2006 12:35 AM
To: ctanasa at i-net.ro; cisco-nsp at puck.nether.net
Subject: Re: [c-nsp] WS-X5410 issue

http://www.cisco.com/en/US/products/hw/switches/ps679/products_installation_
and_configuration_guide09186a008007d1cd.html#4913

>>> "Corneliu Tanasa" <ctanasa at i-net.ro> 05/05/06 04:12PM >>>
 

I have one WS-X5410 9 gigabit port module on a Catalyst 5500 and I noticed a
strange thing.  The hidden command "whichbus <mod>/>port>", for each of the
ports on this module, reports the ports on the same bus (for example it
reports all of the ports on bus A dependin on which slot the board is
inserted).  I know that for X5403, each of the ports is attached on a
different bus, so I expected to have the 9 ports spread across the 3 busses.
Does anyone have any idea?

Thank you,

Corneliu Tanasa

 

_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net 
https://puck.nether.net/mailman/listinfo/cisco-nsp 
archive at http://puck.nether.net/pipermail/cisco-nsp/