[c-nsp] disable flowcontrol on 7200

[Tassos Chatzithomaoglou]

I'm trying to disable flow-control on the GE port of a 7200 NPE-G1 (12.3.18), 
but i'm unable to do it when using the RJ-45 port.

"no negotiation auto" doesn't seem to have any real effect (CSCed05821 ?) and i 
can't find another way of doing it.

Any other idea?

7200
----
interface GigabitEthernet0/2
...
  duplex auto
  speed auto
  media-type rj45
  no negotiation auto


GigabitEthernet0/2 is up, line protocol is up
   Hardware is BCM1250 Internal MAC, address is 0015.634c.2a1a (bia 0015.634c.2a1a)
   Internet address is x.x.x.x
   MTU 1600 bytes, BW 1000000 Kbit, DLY 10 usec,
      reliability 255/255, txload 25/255, rxload 10/255
   Encapsulation ARPA, loopback not set
   Keepalive set (10 sec)
   Full-duplex, 1000Mb/s, media type is RJ45
   output flow-control is XON, input flow-control is XON


3750
----
interface GigabitEthernet1/0/1
  switchport mode access
  switchport nonegotiate
  load-interval 30
  spanning-tree portfast

GigabitEthernet1/0/1 is up, line protocol is up (connected)
   Hardware is Gigabit Ethernet, address is 0014.1cec.1b01 (bia 0014.1cec.1b01)
   MTU 1600 bytes, BW 1000000 Kbit, DLY 10 usec,
      reliability 255/255, txload 10/255, rxload 25/255
   Encapsulation ARPA, loopback not set
   Keepalive not set
   Full-duplex, 1000Mb/s, link type is auto, media type is 10/100/1000BaseTX SFP
   input flow-control is off, output flow-control is unsupported
...
      0 watchdog, 417 multicast, 20 pause input

-- 
Tassos