[c-nsp] 2611XM and VWIC-2MFT-E1-DI

[Alexander Nazarenko]

Dear sirs,

i have the following errors under startup:

*Mar  1 00:06:06.781: %CONTROLLER-2-FIRMWARE: Controller E1 0/0, 
firmware is not running
*Mar  1 00:06:06.781: %CONTROLLER-2-FIRMWARE: Controller E1 0/1, 
firmware is not running
Slot 0:
       C2611XM 2FE Mainboard Port adapter, 3 ports
       Port adapter is analyzed
       Port adapter insertion time unknown
       EEPROM contents at hardware discovery:
       Hardware Revision        : 1.0
       PCB Serial Number        : JAD07130QL2 (282737501)
       Part Number              : 73-7679-02
       RMA History              : 00
       RMA Number               : 0-0-0-0
       Board Revision           : B0
       Deviation Number         : 0-0
       EEPROM format version 4
       EEPROM contents (hex):
         0x00: 04 FF 40 03 6B 41 01 00 C1 17 4A 41 44 30 37 31
         0x10: 33 30 51 4C 32 20 28 32 38 32 37 33 37 35 30 31
         0x20: 29 82 49 1D FF 02 04 00 81 00 00 00 00 42 42 30
         0x30: 80 00 00 00 00 FF FF FF FF FF FF FF FF FF FF FF
         0x40: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
         0x50: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
         0x60: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
         0x70: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF

       WIC Slot 0:
       E1 Drop&Insert & G.703 (2 port) WAN daughter card
       Hardware revision 1.0           Board revision B0
       Serial number     31519092      Part number    800-06724-02
       Test history      0x0           RMA number     00-00-00
       Connector type    PCI
       EEPROM format version 1
       EEPROM contents (hex):
         0x20: 01 30 01 00 01 E0 F1 74 50 1A 44 02 00 00 00 00
         0x30: 58 00 00 00 02 10 30 00 FF FF FF FF FF FF FF FF

Router>sh ver
Cisco IOS Software, C2600 Software (C2600-IPSS7-M), Version 12.3(8)T9, 
RELEASE SOFTWARE (fc2)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2005 by Cisco Systems, Inc.
Compiled Wed 01-Jun-05 11:40 by pwade


After i reboot the router, i have another error:
*Mar  1 00:00:07.828: %E1T1_MODULE-3-INITFAILURE: Slot 0, Unit 0 
initialization failure - FPGA Revision = 0xB
*Mar  1 00:00:07.828: %E1T1_MODULE-3-INITFAILURE: Slot 0, Unit 0 
initialization failure - FPGA & Firmware Download