[c-nsp] VWIC-2MFT-E1-DI doubt

[Ruben Martin]

Hello all,

We are searching for a WIC that supports G.703 for a CISCO 2811. We need two
E1 so we have found two WICs that fulfill our requirements:

VWIC-2MFT-E1-DI &
VWIC-2MFT-G703

The point cames with the support of Unframed E1. We need to find out
if VWIC-2MFT-E1-DI
supports Unframed E1 becouse is cheaper than VWIC-2MFT-G703.

Although the documentation says Unframed E1 G.703 is not supported by
VWIC-2MFT-E1-DI (
http://www-search.cisco.com/en/US/products/hw/routers/ps259/products_data_sheet09186a0080091b9c.html)
we already have one working fine.

        WIC Slot 0:
        E1 Drop&Insert & G.703 (2 port) WAN daughter card
        Hardware revision 1.0           Board revision A0
        Serial number     21525748      Part number    800-06724-02
        Test history      0x0           RMA number     00-00-00
        Connector type    PCI
        EEPROM format version 1
        EEPROM contents (hex):
          0x20: 01 30 01 00 01 48 74 F4 50 1A 44 02 00 00 00 00
          0x30: 50 00 00 00 01 07 08 00 FF FF FF FF FF FF FF FF

controller E1 0/0
 clock source internal
 line-termination 75-ohm
 channel-group 1 unframed

Where is the problem?
Would VWIC-2MFT-E1-DI work with unframed g.703 if we buy it?

Thanks in advance.