[c-nsp] PDSN implementation

[Rivo Tahina RAZAFINDRATSIFA]

Thank you for this answer.

Kind regards.

At 14:50 03/11/2006 -0800, Collins, Richard (SNL US) wrote:
>This is what we have used.  A colleague ran some basic test with Radius
>but without all the attributes you need to really run CDMA (that was my
>understanding).
>
>-Rich
>------------------------------------------------------------------------
>-----------------
>pdsn#sh hardware
>Cisco IOS Software, 7200 Software (C7200-C6IS-M), Version 12.3(11)YF4,
>RELEASE SOFTWARE (fc1)
>Technical Support: http://www.cisco.com/techsupport
>Copyright (c) 1986-2005 by Cisco Systems, Inc.
>Compiled Wed 31-Aug-05 21:58 by evmiller
>
>ROM: System Bootstrap, Version 12.3(4r)T3, RELEASE SOFTWARE (fc1)
>BOOTLDR: 7200 Software (C7200-KBOOT-M), Version 12.3(9), RELEASE
>SOFTWARE (fc2)
>
>pdsn uptime is 12 weeks, 4 days, 6 hours, 45 minutes
>System returned to ROM by power-on
>System image file is "disk2:/c7200-c6is-mz.123-11.YF4.bin"
>
>Cisco 7206VXR (NPE-G1) processor (revision B) with 983040K/65536K bytes
>of memory.
>Processor board ID 34778679
>SB-1 CPU at 700MHz, Implementation 1025, Rev 0.2, 512KB L2 Cache
>6 slot VXR midplane, Version 2.11
>
>Last reset from power-on
>
>PCI bus mb1 (Slots 1, 3 and 5) has a capacity of 600 bandwidth points.
>Current configuration on bus mb1 has a total of 0 bandwidth points. This
>configuration is within the PCI bus capacity and is supported.
>
>PCI bus mb2 (Slots 2, 4 and 6) has a capacity of 600 bandwidth points.
>Current configuration on bus mb2 has a total of 0 bandwidth points. This
>configuration is within the PCI bus capacity and is supported.
>
>Please refer to the following document "Cisco 7200 Series Port Adaptor
>Hardware Configuration Guidelines" on CCO <www.cisco.com>, for c7200
>bandwidth points oversubscription/usage guidelines.
>
>
>3 Gigabit Ethernet interfaces
>509K bytes of NVRAM.
>
>125440K bytes of ATA PCMCIA card at slot 2 (Sector size 512 bytes).
>16384K bytes of Flash internal SIMM (Sector size 256K).
>Configuration register is 0x2102
>
>pdsn#
>
>
>------------------------------
>
>Message: 6
>Date: Thu, 02 Nov 2006 22:29:37 +0300
>From: Rivo Tahina RAZAFINDRATSIFA <r.tahina at wanadoo.mg>
>Subject: [c-nsp] PDSN implementation
>To: cisco-nsp at puck.nether.net
>Message-ID: <5.1.0.14.0.20061102222718.0133d240 at pop.wanadoo.mg>
>Content-Type: text/plain; charset="us-ascii"; format=flowed
>
>Hi all,
>
>I would to know if someone has any idea about using a 7200 box as a CDMA
>
>PDSN, what about hardware config and which IOS to use?
>
>Kind regards.
>
>
>
>
>_______________________________________________
>cisco-nsp mailing list  cisco-nsp at puck.nether.net
>https://puck.nether.net/mailman/listinfo/cisco-nsp
>archive at http://puck.nether.net/pipermail/cisco-nsp/