[c-nsp] EIGRP Routes dropping out of topology table within MPLS VPN

[Eric Kagan]

I have a situation where a customer is running EIGRP within an MPLS VPN.
They will call that a site is "down" and when we issue a 'show ip eigrp vrf
xx top'  the routes are not in there. If you check 'show ip route vrf xx'
they are there.  (I can post with sample tables if necessary).  If I reset
the BGP sessions with the route reflector, they all come back.
 
I have tried 2 different routers, reboots, IOS upgrades, etc  to no avail.
The strange thing is I did an IOS upgrade last night and after the reboot
there were only 21 routes in the top table after thereboot instead of 62.  I
had to clear the BGP sessions right after the reboot ???
 
show vers below of the routers - have tried 12.3(19)P, 12.3(20)P,
12.2.18S12P
I can't find any direct bug notices either ??
 
Anyone seen anything like this ?  We had them on a 7500 a while back and
never had a problem.
 
Thanks
Eric
 
===========================================================================
 
 
Cisco Internetwork Operating System Software
IOS (tm) 7200 Software (C7200-P-M), Version 12.2(18)S12, RELEASE SOFTWARE
(fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2006 by cisco Systems, Inc.
Compiled Thu 25-May-06 12:32 by tinhuang
Image text-base: 0x60008FE0, data-base: 0x61522000
 
ROM: System Bootstrap, Version 12.0(19990210:195103) [12.0XE 105],
DEVELOPMENT SOFTWARE
BOOTLDR: 7200 Software (C7200-BOOT-M), Version 12.0(5)T1,  RELEASE SOFTWARE
(fc1)
 
vxr300-test uptime is 12 hours, 2 minutes
System returned to ROM by reload at 21:59:10 edt Fri Oct 20 2006
System restarted at 22:00:54 edt Fri Oct 20 2006
Running default software
Last reload reason: Reload command
 

cisco 7206VXR (NPE300) processor (revision B) with 262144K/32768K bytes of
memory.
Processor board ID 26813043
R7000 CPU at 262Mhz, Implementation 39, Rev 1.0, 256KB L2 Cache
6 slot VXR midplane, Version 2.6
 
Last reset from power-on
X.25 software, Version 3.0.0.
Bridging software.
 
PCI bus mb0_mb1 has 200 bandwidth points
PCI bus mb2 has 200 bandwidth points
 
2 FastEthernet/IEEE 802.3 interface(s)
125K bytes of non-volatile configuration memory.
 
125184K bytes of ATA PCMCIA card at slot 0 (Sector size 512 bytes).
4096K bytes of Flash internal SIMM (Sector size 256K).
Configuration register is 0x2102
 
 
 
--
 
Cisco Internetwork Operating System Software
IOS (tm) 7200 Software (C7200-P-M), Version 12.3(19), RELEASE SOFTWARE (fc2)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2006 by cisco Systems, Inc.
Compiled Thu 11-May-06 22:37 by evmiller
Image text-base: 0x60008AF4, data-base: 0x61A5C000
 
ROM: System Bootstrap, Version 12.2(4r)B, RELEASE SOFTWARE (fc1)
BOOTLDR: 7200 Software (C7200-BOOT-M), Version 12.0(17)S, EARLY DEPLOYMENT
RELEASE SOFTWARE (fc1)
 
ma.marl.colo-rtr2 uptime is 3 weeks, 4 hours, 35 minutes
System returned to ROM by reload at 05:26:49 edt Sat Sep 30 2006
System restarted at 05:28:44 edt Sat Sep 30 2006
System image file is "slot0:c7200-p-mz.123-19.bin"
Last reload reason: Reload command
 

cisco 7206VXR (NPE400) processor (revision A) with 491520K/32768K bytes of
memory.
Processor board ID 31525253
R7000 CPU at 350MHz, Implementation 39, Rev 3.3, 256KB L2 Cache
6 slot VXR midplane, Version 2.7
 
Last reset from power-on
X.25 software, Version 3.0.0.
Bridging software.
 
PCI bus mb0_mb1 (Slots 0, 1, 3 and 5) has a capacity of 600 bandwidth
points.
Current configuration on bus mb0_mb1 has a total of 400 bandwidth points.
This configuration is within the PCI bus capacity and is supported.
 
PCI bus mb2 (Slots 2, 4, 6) has a capacity of 600 bandwidth points.
Current configuration on bus mb2 has a total of 400 bandwidth points
This configuration is within the PCI bus capacity and is supported.
 
Please refer to the following document "Cisco 7200 Series Port Adaptor
Hardware Configuration Guidelines" on Cisco.com <http://www.cisco.com>
for c7200 bandwidth points oversubscription and usage guidelines.
 

4 FastEthernet/IEEE 802.3 interface(s)
125K bytes of non-volatile configuration memory.
 
24576K bytes of Flash PCMCIA card at slot 0 (Sector size 128K).
4096K bytes of Flash internal SIMM (Sector size 256K).
Configuration register is 0x2102