[c-nsp] Cisco 878W with no G.SHDSL interface?

[Johannes Resch]

You should be able to configure

controller DSL 0
   mode atm
   <other DSL parameters>

Then you'll have a ATM0 interface.

regards,
-jr

Skeeve Stevens schrieb:
> This is a new one for me.
> 
> Took delivery of a new 878W.  Had to upgrade the flash to 32mb to handle the
> advanced security image.
> 
> Tftpdnld'd the image onto the flash. all fine.
> 
> Boot the unit... And:
> 
> Show ver:
> 
> Cisco 878W (MPC8272) processor (revision 0x200) with 118784K/12288K bytes of
> memory.
> Processor board ID FHK102821PG
> MPC8272 CPU Rev: Part Number 0xC, Mask Number 0x10
> 4 FastEthernet interfaces
> 1 ISDN Basic Rate interface
> 1 802.11 Radio
> 128K bytes of non-volatile configuration memory.
> 53248K bytes of processor board System flash (Intel Strataflash)
> 
> 
> Umm. where has the ATM interface gone?  It is the latest possible 12.4
> firmware  c870-advsecurityk9-mx.124-9.T1.bin
> 
> Anyone have any idea why the ATM/SHDSL wouldn't be showing up?
> 
> .Skeeve
> 
> _______________________________________________________
> Skeeve Stevens, RHCE     Email: skeeve at skeeve.org
> Website: www.skeeve.org  - Telephone: (0414) 753 383
> Address: P.O Box 1035, Epping, NSW, 1710, Australia
> 
> eIntellego - skeeve at eintellego.net - www.eintellego.net
> _______________________________________________________
> I'm a groove licked love child king of the verse
> Si vis pacem, para bellum
> 
> 
> 
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
> 
>