[c-nsp] Incompatibility for send-label between Cisco and Juniper?

[Alex]

Do You have both "family inet" and "family labeled-unicast" enabled under
[edit protocols bgp] on Juniper side?
HTH
Cheers
Alex

----- Original Message ----- 
From: "Jason Koh" <kohtohshyr at pacific.net.sg>
To: <cisco-nsp at puck.nether.net>
Sent: Friday, September 22, 2006 11:22 AM
Subject: [c-nsp] Incompatibility for send-label between Cisco and Juniper?


> Hi all
>
> I encountered something strange with the neighbor <peer> send-label 
> command under router bgp. When I attach a route-map controlling which 
> labels to send, instead of restricting labels to send, it completely fails 
> to advertise routes besides the one specified in the prefix-list. This 
> problem does not happen between Cisco and Cisco.
>
> Here are my output for the Cisco to Juniper.
>
> With the send-label command:
>
> test22#sh ip bgp neighbors 10.169.34.1 advertised-routes
> BGP table version is 183, local router ID is 192.168.38.22
> Status codes: s suppressed, d damped, h history, * valid, > best, i - 
> internal,
>              r RIB-failure, S Stale
> Origin codes: i - IGP, e - EGP, ? - incomplete
>
>   Network          Next Hop            Metric LocPrf Weight Path
> r>i192.168.38.19/32 192.168.38.19            0    100      0 i
>
> Total number of prefixes 1
>
> Without the send-label command:
>
> test22#sh ip bgp neighbors 10.169.34.1 advertised-routes
> BGP table version is 175, local router ID is 192.168.38.22
> Status codes: s suppressed, d damped, h history, * valid, > best, i - 
> internal,
>              r RIB-failure, S Stale
> Origin codes: i - IGP, e - EGP, ? - incomplete
>
>   Network          Next Hop            Metric LocPrf Weight Path
> r>i99.99.99.1/32    192.168.38.19            0    100      0 i
> *> 172.16.100.0/24  0.0.0.0                  0         32768 i
> *>i192.168.0.0      192.168.38.19            0    100      0 3 i
> r>i192.168.38.19/32 192.168.38.19            0    100      0 i
>
> Config as follows
>
> address-family ipv4
> neighbor 10.169.34.1 activate
> neighbor 10.169.34.1 soft-reconfiguration inbound
> neighbor 10.169.34.1 route-map TEST out
> neighbor 10.169.34.1 send-label
>
> route-map TEST permit 10
> match ip address prefix-list TEST
> set mpls-label
> !
> route-map TEST permit 20
>
> ip prefix-list TEST seq 5 permit 192.168.38.19/32
>
> Total number of prefixes 4
>
> Hopefully someone can help me with this. Thanks.
>
>
> Jason Koh
> Senior Network Engineer
> Pacific Internet Ltd
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>