[c-nsp] %LINK-4-ERROR and %CDP-4-DUPLEX_MISMATCH
Bagosi Rómeó
Romeo.Bagosi at integris.hu
Tue Apr 3 11:05:17 EDT 2007
The problem is that this link is very important...
I've trusted that will be some other solution for this:(
You think that if the TX/RX is now inverted, the network works (with some errors)?
-----Original Message-----
From: Koch, Christian [mailto:ckoch at qualitytech.com]
Sent: Tuesday, April 03, 2007 4:56 PM
To: Bagosi Rómeó; cisco-nsp at puck.nether.net
Subject: RE: [c-nsp] %LINK-4-ERROR and %CDP-4-DUPLEX_MISMATCH
have you tried swapping out the fiber? Maybe switching tx/rx ?
|-----Original Message-----
|From: Bagosi Rómeó [mailto:Romeo.Bagosi at integris.hu]
|Sent: Tuesday, April 03, 2007 10:53 AM
|To: Koch, Christian; cisco-nsp at puck.nether.net
|Subject: RE: [c-nsp] %LINK-4-ERROR and %CDP-4-DUPLEX_MISMATCH
|
|Hi Christian!
|
|I don't tried it, but on the C2924 I cannot change the media
|type, only on the C2960 side...
|I think the media type on the C2960 is set to auto, and it
|recognizes as SFP. I think this is ok...
|
|C2960: Half-duplex, 100Mb/s, link type is auto, media type is
|100BaseFX SFP
|
|
|-----Original Message-----
|From: Koch, Christian [mailto:ckoch at qualitytech.com]
|Sent: Tuesday, April 03, 2007 2:44 PM
|To: Bagosi Rómeó; cisco-nsp at puck.nether.net
|Subject: RE: [c-nsp] %LINK-4-ERROR and %CDP-4-DUPLEX_MISMATCH
|
|Try setting the media type under the interface on the 2924?
|
||-----Original Message-----
||From: cisco-nsp-bounces at puck.nether.net
||[mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of Bagosi Rómeó
||Sent: Tuesday, April 03, 2007 5:27 AM
||To: cisco-nsp at puck.nether.net
||Subject: [c-nsp] %LINK-4-ERROR and %CDP-4-DUPLEX_MISMATCH
||
||Hi all Experts!
||
||
||
||I have the following problem:
||
||We have two switch connected by fiber cable:
||
||
||
||WS-C2960G-24TC-L:Gi0/21<<<<< >>>>> Fa1/4:WS-C2924M-XL
||
|| FIBER
||
||
||
||The problem is, that the C2924 Switch sends the following messages in
||every minute:
||
||
||
||Apr 3 08:11:33.112 MET-DST: %LINK-4-ERROR: FastEthernet1/4 is
||experiencing errors
||
||
||
||On the C2960 I cannot change the duplex or the speed settings.
||
||On the C2924 I've changed the duplex settings, but:
||
||- If it's set to duplex auto or duplex full, then
||%CDP-4-DUPLEX_MISMATCH error on the C2960 Switch
||
||- If it's set to duplex half, then %LINK-4-ERROR on
||the C2924 Switch
||
||
||
||Why the newer Cisco Devices and IOS doesn't support the speed and
||duplex settings?
||
||Does these errors highly affect the network performance?
||
||Is there any solution for this problem?
||
||
||
||
||
||Thank you in anticipation!
||
||
||
||
||
||C2924# sh int fa1/4
||
||FastEthernet1/4 is up, line protocol is up
||
|| Hardware is Fast Ethernet, address is 0004.9a20.63e0 (bia
||0004.9a20.63e0)
||
|| MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
||
|| reliability 250/255, txload 7/255, rxload 1/255
||
|| Encapsulation ARPA, loopback not set
||
|| Keepalive not set
||
|| Half-duplex, 100Mb/s, 100BaseFX
||
|| ARP type: ARPA, ARP Timeout 04:00:00
||
|| Last input 00:00:06, output 00:00:00, output hang never
||
|| Last clearing of "show interface" counters never
||
|| Queueing strategy: fifo
||
|| Output queue 0/40, 0 drops; input queue 0/75, 0 drops
||
|| 5 minute input rate 588000 bits/sec, 440 packets/sec
||
|| 5 minute output rate 2890000 bits/sec, 530 packets/sec
||
|| 1752297879 packets input, 4205642061 bytes
||
|| Received 6728883 broadcasts, 0 runts, 0 giants, 0 throttles
||
|| 5814363 input errors, 5814363 CRC, 0 frame, 58583 overrun, 61143
||ignored
||
|| 0 watchdog, 1817612 multicast
||
|| 0 input packets with dribble condition detected
||
|| 2107649242 packets output, 3958607124 bytes, 12 underruns
||
|| 12023160 output errors, 7511084 collisions, 8 interface resets
||
|| 0 babbles, 12023160 late collision, 12054327 deferred
||
|| 0 lost carrier, 0 no carrier
||
|| 12 output buffer failures, 0 output buffers swapped out
||
||
||
||C2960#sh int Gi0/21
||
||GigabitEthernet0/21 is up, line protocol is up (connected)
||
|| Hardware is Gigabit Ethernet, address is 0018.73ec.5b95 (bia
||0018.73ec.5b95)
||
|| MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
||
|| reliability 252/255, txload 1/255, rxload 6/255
||
|| Encapsulation ARPA, loopback not set
||
|| Keepalive not set
||
|| Half-duplex, 100Mb/s, link type is auto, media type is 100BaseFX SFP
||
|| input flow-control is off, output flow-control is unsupported
||
|| ARP type: ARPA, ARP Timeout 04:00:00
||
|| Last input 00:00:00, output 00:00:04, output hang never
||
|| Last clearing of "show interface" counters never
||
|| Input queue: 0/75/0/0 (size/max/drops/flushes); Total
|output drops: 0
||
|| Queueing strategy: fifo
||
|| Output queue: 0/40 (size/max)
||
|| 5 minute input rate 2735000 bits/sec, 519 packets/sec
||
|| 5 minute output rate 599000 bits/sec, 440 packets/sec
||
|| 1744270788 packets input, 3129573151 bytes, 0 no buffer
||
|| Received 61767996 broadcasts (0 multicast)
||
|| 0 runts, 0 giants, 0 throttles
||
|| 11288249 input errors, 11288249 CRC, 0 frame, 0 overrun,
|0 ignored
||
|| 0 watchdog, 16264953 multicast, 0 pause input
||
|| 0 input packets with dribble condition detected
||
|| 1466543564 packets output, 2681409739 bytes, 0 underruns
||
|| 0 output errors, 15260833 collisions, 1 interface resets
||
|| 0 babbles, 6268873 late collision, 0 deferred
||
|| 0 lost carrier, 0 no carrier, 0 PAUSE output
||
|| 0 output buffer failures, 0 output buffers swapped out
||
||
||
||
||
||_______________________________________________
||cisco-nsp mailing list cisco-nsp at puck.nether.net
||https://puck.nether.net/mailman/listinfo/cisco-nsp
||archive at http://puck.nether.net/pipermail/cisco-nsp/
||
|
More information about the cisco-nsp
mailing list