[c-nsp] 7600/6500 Power Supplies

[Raman Sud]

Depends upon the power supply and the SUP that you are using

If u are using a SUP2/MSFC2 the 110V will be fine..

If you are using a SUP720...then you will need Phase 1 208V 30 AMP
circuit to power the whole stack

Raman 

-----Original Message-----
From: cisco-nsp-bounces at puck.nether.net
[mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of Dale Shaw
Sent: Thursday, April 26, 2007 4:13 PM
To: cisco-nsp at puck.nether.net
Subject: Re: [c-nsp] 7600/6500 Power Supplies

Hi Matt,

On 4/27/07, Matt Stevens <matt at elevate.org> wrote:
> What capacity power supplies should I be looking at? Can I reasonably
> stay at 110V, since it's a lot easier to get in most colo facilities?
Is
> there a could rule of thumb for figuring this out?

Check out the Power Calculator:
http://www.cisco.com/go/powercalculator

cheers,
Dale
_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/