[c-nsp] cisco 2811 and adsl2+ hwic...
fernando fernandes
op306685b at mail.telepac.pt
Fri Aug 3 13:32:29 EDT 2007
lo guys ...
so i have the cisco 2811 with and hwic-adsl , the thing is i'm only able
of getting about 1.6MB/S in download...
here's a copy of the adsl2+ sync...
cisco2811#sh dsl int atm0/0/0
ATM0/0/0
Alcatel 20190 chipset information
ATU-R (DS) ATU-C (US)
Modem Status: Showtime (DMTDSL_SHOWTIME)
DSL Mode: ITU G.992.5 (ADSL2+) Annex A
ITU STD NUM: 0x03 0x1
Chip Vendor ID: 'STMI' 'IFTN'
Chip Vendor Specific: 0x0000 0x70DE
Chip Vendor Country: 0x0F 0xB5
Modem Vendor ID: 'CSCO' ' '
Modem Vendor Specific: 0x0000 0x0000
Modem Vendor Country: 0xB5 0x00
Serial Number Near: FOC10131QRECISCO73993205
Serial Number Far: Chip ID: C196 (0)
DFE BOM: DFE3.0 Annex A (1)
Chip ID: C196 (0)
DFE BOM: DFE3.0 Annex A (1)
Capacity Used: 94% 50%
Noise Margin: 7.0 dB 20.5 dB
Output Power: 15.0 dBm 12.5 dBm
Attenuation: 16.0 dB 5.0 dB
Defect Status: None None
Last Fail Code: None
Watchdog Counter: 0xF8
Watchdog Resets: 0
Selftest Result: 0x00
Subfunction: 0x00
Interrupts: 17689 (0 spurious)
PHY Access Err: 0
Activations: 3
LED Status: OFF
LED On Time: 0
LED Off Time: 0
Init FW: init_3.0.33_nobist.bin
Operation FW: AMR-3.0.033.bin
FW Source: external
FW Version: 3.0.33
DS Channel1 DS Channel0 US Channel1 US
Channel0
Speed (kbps): 0 23999 0 509
anyone have ideas where i can tunne this baby?
with other router (speedtouch 546) i'm able of achieving 2.4MB/S
here's a past of the dialer0
interface Dialer0
description TELEPAC
bandwidth 512
bandwidth receive 23999
ip address negotiated
no ip redirects
no ip unreachables
no ip proxy-arp
ip mtu 1492
ip nat outside
ip virtual-reassembly
encapsulation ppp
ip route-cache flow
ip tcp adjust-mss 1452
no ip mroute-cache
dialer pool 1
dialer idle-timeout 0
dialer persistent
dialer-group 1
no cdp enable
ppp authentication chap pap callin
More information about the cisco-nsp
mailing list