[c-nsp] ASA 5510 - 4GE SSM Problem

[ChrisSerafin]

I thought you had an IPS SSM device,,,,sorry




Krishna Kishore wrote:
> Hi Chris,
>
> Thanks for your reply. I try to configure the session in the ASA but it is
> not creating and showing the following error.
>
> ciscoasa(config)# session 1
> Opening command session with slot 1.
> Card in slot 1 did not respond to session request.
>
> Surpricingly, the 'Status' LED in the device is glowing stable green and
> power is also ok.
>
> Any clue plz.
>
> Regards,
>
> Kris.
>
> ----- Original Message -----
> From: "ChrisSerafin" <chris at chrisserafin.com>
> To: "Krishna Kishore" <krishna.kishore at ucom.bi>
> Cc: <cisco-nsp at puck.nether.net>
> Sent: Thursday, August 16, 2007 5:26 PM
> Subject: Re: [c-nsp] ASA 5510 - 4GE SSM Problem
>
>
>   
>> It will not show up in the ASA configs. You need to 'session 1' i
>> believe into the device. This will log you into the SSM device. It has
>> it's own IP addressing and GUI.  Think of it a separate device.
>>
>> Chris Serafin
>> Security Engineer
>> chris at chrisserafin.com
>>
>>
>> Krishna Kishore wrote:
>>     
>>> Hi All,
>>>
>>> I have a problem in installing 4 GE SSM module in my ASA 5510. I just
>>>       
> bought a new module 4GE SSM and installed as per the instructions. But if I
> check in "sh run" I am not able to find the interfaces. Do I need to do
> extra any configurations? I try to check the Cisco site but I couldn't find
> a solution.
>   
>>> Any clue to install it.
>>>
>>> Thanks in Advance,
>>>
>>> Kris.
>>> _______________________________________________
>>> cisco-nsp mailing list  cisco-nsp at puck.nether.net
>>> https://puck.nether.net/mailman/listinfo/cisco-nsp
>>> archive at http://puck.nether.net/pipermail/cisco-nsp/
>>>
>>>
>>>
>>>
>>>       
>> _______________________________________________
>> cisco-nsp mailing list  cisco-nsp at puck.nether.net
>> https://puck.nether.net/mailman/listinfo/cisco-nsp
>> archive at http://puck.nether.net/pipermail/cisco-nsp/
>>
>>     
>
>
>
>
>