[c-nsp] Bridge between Serial and ethernet

[Bruce Pinsky]

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Everton da Silva Marques wrote:
> On Thu, Aug 16, 2007 at 06:14:32PM +0300, tojonirina.raonisoafianinana at dts.mg wrote:
>> I want to establish a connexion between the ?? Serial interface 1 ??
>> and ?? the ethernet interface 1 ??, its must be inside the same
>> pool address (for e.g /30 netmask). For this, the router in the
>> middle must be really transparent (bridge). 
>>
>> Is it possible to establish this link ? If yes, could someone
>> help us for the configuration ? 
> 
> Search for the following commands:
> 
> interface Ethernet1
>  bridge-group 2
> !
> interface Serial1
>  bridge-group 2
> !
> bridge 2 protocol ieee

And you would need to add "no ip routing".  Of course, it wasn't clear from
his initial email if the serial interface was on device and the ethernet
was on the other.  In that case, you have an issue because you have
different encaps on each end of the link.

- --
=========
bep

-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.4 (MingW32)
Comment: Using GnuPG with Mozilla - http://enigmail.mozdev.org

iD8DBQFGxKcSE1XcgMgrtyYRAkIDAJ9qKnco7DgCdvp/zP8gI/Gzd1TpXgCguPQl
GAdiuRxYz3xJ9zdI4BvUZTA=
=xATs
-----END PGP SIGNATURE-----