[c-nsp] Cannot boot 6506 off disk0:

Todd, Douglas M. DTODD at PARTNERS.ORG
Fri Feb 23 11:42:10 EST 2007


What does your boot var look like in your config?

 

> -----Original Message-----
> From: cisco-nsp-bounces at puck.nether.net 
> [mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of Anton Smith
> Sent: Friday, February 23, 2007 11:22 AM
> To: Miquel van Smoorenburg
> Cc: cisco-nsp at puck.nether.net
> Subject: Re: [c-nsp] Cannot boot 6506 off disk0:
> 
> Miquel van Smoorenburg wrote:
> > On Fri, 2007-02-23 at 14:24 +0000, Anton Smith wrote:
> >> Hi all,
> >>
> >> I have run into a weird issue where I cannot get a 6506 to 
> boot from 
> >> disk0 - instead it boots into ROMMON and gets stuck there, 
> until I tell it:
> >>
> >> boot disk0:
> >>
> >> - at which point it loads fine.
> > 
> > Did you format disk0 ? If not, format, try again.
> > 
> > Mike.
> >  
> 
> I'm fairly sure it has been formatted - I pulled it out of 
> another SUP 720 where it was booting fine..
> 
> However, not being 100% certain of this, I will try it. What 
> is the usual process for formatting the disk?
> 
> Regards,
> Anton
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net 
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
> 





The information transmitted in this electronic communication is intended only for the person or entity to whom it is addressed and may contain confidential and/or privileged material. Any review, retransmission, dissemination or other use of or taking of any action in reliance upon this information by persons or entities other than the intended recipient is prohibited. If you received this information in error, please contact the Compliance HelpLine at 800-856-1983 and properly dispose of this information.




More information about the cisco-nsp mailing list