[c-nsp] ghost module & interface in 6509/SUP720 ;)
Tassos Chatzithomaoglou
achatz at forthnet.gr
Mon Jan 15 07:26:56 EST 2007
After moving WS-X6408A-GBIC from slot 7 to slot 9 on a 6509/SUP720 (12.2(18)SXF6), i have the following results:
6509#sh mod 7
% no module in that slot
6509#sh mod
Mod Ports Card Type Model Serial No.
--- ----- -------------------------------------- ------------------ -----------
1 24 CEF720 24 port 1000mb SFP WS-X6724-SFP SAL10360MY1
6 2 Supervisor Engine 720 (Active) WS-SUP720-3BXL SAL10360DSF
9 8 8 port 1000mb GBIC Enhanced QoS WS-X6408A-GBIC SAD04450121
but:
6509#sh int gi7/1
GigabitEthernet7/1 is administratively down, line protocol is down (disabled)
Hardware is not present
Hardware is C6k 1000Mb 802.3, address is 00d0.04fd.e000 (bia 00d0.04fd.e000)
6509#conf t
Enter configuration commands, one per line. End with CNTL/Z.
6509(config)#int gi7/1
6509(config-if)#no shut
6509(config-if)#^Z
6509#sh int gi7/1
GigabitEthernet7/1 is down, line protocol is down (notconnect)
Hardware is not present
Hardware is C6k 1000Mb 802.3, address is 00d0.04fd.e000 (bia 00d0.04fd.e000)
6509#sh run int gi7/1
Building configuration...
Current configuration : 51 bytes
!
interface GigabitEthernet7/1
no ip address
end
6509#sh int gi7/1 capabilities
GigabitEthernet7/1
Dot1x: yes
Model: NO IDPROM
Type: 1000BaseLH
Speed: 1000
Duplex: full
Trunk encap. type: 802.1Q,ISL
Trunk mode: on,off,desirable,nonegotiate
Channel: yes
Broadcast suppression: percentage(0-100)
Flowcontrol: rx-(off,on,desired),tx-(off,on,desired)
Membership: static
Fast Start: yes
QOS scheduling: rx-(1p1q4t), tx-(1p2q2t)
CoS rewrite: yes
ToS rewrite: yes
Inline power: no
SPAN: source/destination
UDLD yes
Link Debounce: yes
Link Debounce Time: yes
Ports on ASIC: 1-8
Port-Security: yes
--
Tassos
More information about the cisco-nsp
mailing list