[c-nsp] 3845 with VWIC2-2MFT-T1/E1 and NM-2FE2W-V2

[Joe Maimon]

Two problems

1) Cant seem to configure the controller

Cisco IOS Software, 3800 Software (C3845-ADVENTERPRISEK9-M), Version 
12.4(12), R
ELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2006 by Cisco Systems, Inc.
Compiled Fri 17-Nov-06 15:53 by prod_rel_team

ROM: System Bootstrap, Version 12.3(11r)T2, RELEASE SOFTWARE (fc1)

Router uptime is 11 minutes
System returned to ROM by power-on


Cisco 3845 (revision 1.0) with 221184K/40960K bytes of memory.

2 FastEthernet interfaces
2 Gigabit Ethernet interfaces
2 Channelized (E1 or T1)/PRI ports
1 Virtual Private Network (VPN) Module
DRAM configuration is 64 bits wide with parity enabled.
479K bytes of NVRAM.
125184K bytes of ATA System CompactFlash (Read/Write)

Configuration register is 0x2102

Router# sh controllers t1

Router# sh controllers e1

Router# sh controllers async

Router# sh controllers j1

Router#


Router(config)#controller t1
                       ^
% Invalid input detected at '^' marker.

Router(config)#
Router(config)#controll?
% Unrecognized command
Router(config)#cont?
control-plane

Router(config)#cont

2)

The FE ports on the NM seem to have 80% packet loss at full size packets.

Anybody have any ideas?