[c-nsp] SNMP Temperature C3750 C2960

[Mihai Tanasescu]

> > I have some C3750 and C2960 equipments and I'm trying to get some
> > temperature status info out of them.
> >
> > As far as I've seen these 2 models don't have a sensor built-in for
> > more specific information(numerical temp. values) but from the CLI
> > I can observe: #show env  temperature TEMPERATURE is OK
> >

 >Also don't miss this:

 >     #show env temp stat
 >    Temperature Value: 37 Degree Celsius
 >     Temperature State: GREEN
 >     Yellow Threshold : 45 Degree Celsius
 >     Red Threshold    : 65 Degree Celsius

> >
> > Is there any SNMP OID that I can query to get an integer value like
> > 1 for OK, 2 for something else ?
> >

 >Here are two possibilities:

 >CISCO-STACK-MIB::chassisTempAlarm.0 = INTEGER: off(1)
 >CISCO-ENVMON-MIB::ciscoEnvMonTemperatureState.1005 = INTEGER: normal(1)

> >
> > So far I've tried (picked up from a forum, but unfortunately it was
> > for C3550, C2950):
> > 
cisco.ciscoMgmt.ciscoEnvMonMIB.ciscoEnvMonObjects.ciscoEnvMonTemperatureStatusTable.ciscoEnvMonTemperatureStatusEntry.ciscoEnvMonTemperatureState
> >  and used the Cisco OID locator tool to see the OID behind it.
> >
> > I tried to query my equipments with that OID but found out that it
> > didn't exist for C3750 and 2960.
> >

 >It works here...

 > SNMP table: CISCO-ENVMON-MIB::ciscoEnvMonTemperatureStatusTable
 > index            StatusDescr        StatusValue          
Threshold      LastShutdown  State
 > 1005 SW#1, Sensor#1, GREEN  37 degrees Celsius 65 degrees Celsius 0 
degrees Celsius normal

 > Note the unique index for each testpoint/stack member.


Hello,


"show env temp stat" doesn't show any values just:

c3750#show env temperature status
Temperature Value: Not Supported
Temperature State: Not Supported


chassisTempAlarm.0 = 1.3.6.1.4.1.9.5.1.2.13.0 shows 1 = off

ciscoEnvMonTemperatureState is not supported


I presume (correct me if I'm wrong) that the previous chassisTempAlarm 
was what I was looking for (I guess it should become 2 = on in case of a 
heat problem)



Thanks,
Mihai