[c-nsp] Catalyst 2950G Trunking Issue

[Nick Griffin]

Didn't get your config. "switchport mode trunk" on both sides should be a
good start. I believe they only run dot1q, so you can't set the
encapsulation. Make sure your vlan 1 interfaces are up.

On 3/16/07, Juan C. Crespo R. <jcposeidon at cantv.net> wrote:
>
> Hi Dears
>
> I'm getting problems trunking two Catalyst 2950G, I try a lot of things
> and I can't make it works. the VLAN 1 on both sides, can't make ping
> each other, and neither Telnet or  SSH, Anyone could send me a config
> examples about trunking on two 2950G?
>
> Thanks
>
> this is my config
>
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>